Accessories; Hydraulic Fluid Level; Lubrication; Machine Storage - RIDGID 920 Manual Del Operador

920 Roll Groover
2. Insert pin in angled hole on transport cart.
3. Place the groover support legs into the base and
insert the hitch pins (Figure 25). The support legs
can be used as handles to wheel the groover to
the work area.
Figure 25 – Attaching the Support Legs

Accessories

Only the following RIDGID products have
WARNING
been designed to function with the 920 Roll Groover.
Other accessories suitable for use with other tools may
become hazardous when used on this Roll Groover.
To prevent serious injury, use only the accessories listed
below.
Catalog Model
No. No. 920 Accessories
10843 — Roll Set for 2" - 6" Schedule 10, 40
96997 — Roll Set for 4" - 6" Schedule 10, 40
10848 — Roll Set for 8" - 12" Schedule 10, 40
10853 — Roll Set for 14" - 16" Std. Wall
96987 — Roll Set for 18" - 20" .250 Wall
96992 — Roll Set for 22" - 24" .250 Wall
96982 — Roll Set for 2" - 6" Copper Tubing (Types K,L,M,DMV)
76822 — English Diameter Tape
76827 — Metric Diameter Tape
96372 RJ-624 6" - 24" Dia. Pipe Stands (See Ridge Tool Catalog)
NOTE: A Roll Set Consists of a Groove Roll and a Drive Roll.
NOTE! See Ridge Tool catalog for complete listing of
pipe stands.
920 Roll Groover Maintenance
Instructions
Make sure machine is unplugged from
WARNING
power source before performing maintenance or making
any adjustments.

Hydraulic Fluid Level

Raise the upper groove roll housing by placing the pump
release lever in the RETURN position.
Remove the pump from the lower roll housing.
Rotate the pump 180º so the filler cap is pointed up.
Raise the pump as much as possible.
Remove the filler cap and fill the reservoir with oil. Replace
filler cap.
Put the pump back onto its position on the lower roll
housing. Tighten all fasteners holding the pump in place.

Lubrication

Drive Shaft and Groove Roll Shaft Bearings
Lubricate with multi-purpose grease through fittings locat-
ed on groove roll shaft and lower roll housing monthly or
after every roll change.

Machine Storage

WARNING
doors or well covered in rainy weather. Store the machine
in a locked area that is out of reach of children and peo-
ple unfamiliar with roll groover equipment. This machine
can cause serious injury in the hands of untrained users.

Service and Repair

Service and repair work on this Roll Groover must be
performed only by qualified repair personnel. Machine
should be taken to a RIDGID Independent Authorized
Service Center or returned to the factory. All repairs
made by Ridge service facilities are warranted against
defects in material and workmanship.
WARNING
tical replacement parts should be used. Failure to follow
these instructions may create a risk of serious injury.
If you have any questions regarding the service or
repair of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: TechServices@ridgid.com
For name and address of your nearest Independent
Authorized Service Center, contact the Ridge Tool Com-
pany at (800) 519-3456 or http://www.ridgid.com
Ridge Tool Company
Motor-driven equipment must be kept in-
When servicing this machine, only iden-
15