Petzl NAVAHO BOD Instrucciones De Uso página 5

F ROPE ACCESS
Diagram 5. EN 813: 1997 seat harness
Ventral attachment point
The EN 813: 1997 standard
concerns seat harnesses that
are used in work positioning,
restraint, and rope access
systems when a low attachment
point is necessary.
Use this ventral ring to attach a
descender, positioning lanyards
or progression lanyards.
This attachment point should
not be used to attach fall arrest
systems.
G
Compatibility: attachment points /
connectors
An incompatible connection can cause
accidental disconnection, breakage, or
affect the safety function of another piece of
equipment.
WARNING, the attachment points of your
harness can act as a lever on the gate of a
connector.
When a sudden tension comes onto the rope
and/or an external pressure on the locking
system, and the connector is poorly positioned,
the locking sleeve can break and the gate can
open itself.
To reduce this risk, check that your connectors
are properly positioned each time the system is
loaded (lanyard, descender, etc.).
Also make sure your connectors are compatible
with the attachment points (shape, size, etc.)
by avoiding the use of connectors showing a
tendency to position themselves incorrectly
(and stably) in the attachment points.
EN 365: WARNING
Compatibility
Check that this product is compatible with the
other components of your equipment, see the
instructions specific to the products.
WARNING, when using multiple pieces of
equipment together, a dangerous situation
can result if the safety function of one piece of
equipment is compromised by the operation of
another piece of equipment.
Contact Petzl if you are uncertain about the
compatibility of your equipment.
Anchors: Work at height
The anchor point of the system should
preferably be located above the user's position
and must conform to the requirements of the
EN 795 standard, in particular the minimum
strength of the anchor must be 10 kN.
5
NAVAHO BOD / NAVAHO BOD FAST
ASCENSION
+ EN 354
LANYARD
I'D
Rescue plan
You must have a rescue plan and the means
to rapidly implement it in case of difficulties
encountered while using this equipment. This
implies an adequate training in the necessary
rescue techniques.
Connectors
Carabiners must always be used with the gate
closed and locked. Systematically verify the
gate is closed by pressing it with your hand.
Inspect the connectors as indicated in their
Instructions for use.
Various
- WARNING DANGER: do not allow this product
to rub against abrasive materials or sharp
edges.
- Users must be medically fit for activities
at height. WARNING, inert suspension in a
harness can result in serious injury or death.
- You must check to ensure that the product
markings remain legible during the entire
lifetime of the product.
- You must verify the suitability of this
equipment for use in your application with
regard to applicable governmental regulations
and other standards on occupational safety.
- The instructions for use for each item of
equipment used in conjunction with this
product must be respected.
- The instructions for use must be provided
to users of this equipment. If the equipment
is re-sold outside the original country of
destination the reseller shall provide these
instructions in the language of the country in
which the product is to be used.
C715060A (240810)
Examples:
I'D
or Type
C rope
adjustment
devices
H
Equipment loop maximum load
10 kg 10 kg
maxi maxi
Slot
for tool
carrier
15 kg
maxi
10 kg
maxi