ABB ACS880-01 Serie Guía Rápida De Instalación página 11

Ocultar thumbs Ver también para ACS880-01 Serie:
Tabla de contenido

Publicidad

A
A = TN-S system, B1 = Corner-grounded system, B2 = Midpoint-grounded system, C = IT system
WARNING! Do not install the drive with EMC filter options +E200 and +E202
connected to a system that the filter is not suitable for. This can cause danger,
or damage the drive.
WARNING! Do not install the drive with the ground-to-phase varistor
connected to a system that the varistor is not suitable for. If you do, the varistor
circuit can be damaged. See the drive hardware manual.
Note: With option +E201, remove EMC AC, EMC DC and VAR screws in for systems
other than TN-S if not removed at the factory. For more information, contact ABB.
Check the insulation of the input and motor cables and the
motor
Check the insulation of the input cable according to local regulations before
connecting it to the drive.
Check the insulation of the motor cable and motor when the cable is disconnected
from the drive, see figure
each phase conductor and the Protective Earth conductor using a measuring voltage
of 1000 V DC. The insulation resistance of an ABB motor must exceed 100 Mohm
(reference value at 25 °C or 77 °F). For the insulation resistance of other motors,
B1
L1
L2
L3
N
PE
B2
D
on page 105. Measure the insulation resistance between
EN – USA quick installation guide 11
L1
L2
L3
PE
L1
L2
L3
PE
C
L1
L2
L3
DA
USA
DA
DE
ES
FI
FR
IT
NL
PT
RU
SV
TR
CN

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido