Step 9 Start Icemaker; Step 10 Install Toekick - Monogram FZIR360NNRH Instrucciones De Instalación

Installation Instructions - Stainless Steel Installation
STEP 8 CONNECT WATER SUPPLY
(FREEZER MODELS ONLY)
(Cont.)
Copper Tubing:
• Slip a 1/4" nut and ferrule (provided) over both ends
of the copper tubing. Insert the tube into the union
fitting on the unit and tighten the nut to the union.
• Turn on the water to check for leaks.
SmartConnect Tubing:
™
NOTE: The only Monogram-approved plastic tubing is
supplied in the SmartConnect
Do not use any other plastic water supply line because
the line is under pressure at all times. Other types of
plastic may crack or rupture with age and cause water
damage to your home.
• Insert the molded end of the tubing into the appliance
or freezer connection. Tighten the compression nut
until it is just hand-tight.
• Tighten one additional turn with a wrench.
Overtightening can cause leaks!
• Turn on the water to check for leaks.
NOTE: Make sure excess tubing length does not
interfere with the toekick installation.
31-1000416 Rev. 0
™
Refrigerator Tubing kits.

STEP 9 START ICEMAKER

(FREEZER MODELS ONLY)
CAUTION
To minimize the risk of personal
injury, avoid contact with the moving parts of the ejector
mechanism, or with the heating element that releases the
cubes. Do not place fingers or hands on the automatic ice
making mechanism while the appliance is plugged in.
ATTENTION
Afin de réduire le risque de blessure,
évitez tout contact avec les pièces mobiles du mécanisme
d'éjection ou l'élément chauffant qui libère les cubes. Ne
placez pas les doigts ou les mains sur le mécanisme de
production de glace automatique lorsque l'électroménager
est branché dans la prise électrique.
PRECAUCIÓN
lesiones personales, evite el contacto con las partes móviles
del mecanismo eyector o con el elemento de calefacción
que libera los cubos. No coloque los dedos ni las manos en
el mecanismo de la máquina de hielo automática mientras el
electrodoméstico se encuentre enchufado.
• The icemaker will begin operation automatically.
• Be sure nothing interferes with the sweep of the feeler
arm.
• Discard the first full bucket of ice cubes.
• To turn the icemaker off, slide the switch to OFF.
Power Switch

STEP 10 INSTALL TOEKICK

• Locate the supplied toekick (shipped taped to the side
of the appliance). Install the toekick assembly with the
2 screws provided, adjust to the desired height and
tighten the screws.
IMPORTANT: A custom toekick can be installed to
match or complement the surrounding cabinetry but
can NOT cover the horizontal vent slots of the factory
toe kick.
35
Para minimizar el riesgo de
Icemaker
Feeler Arm