Step 9 Install Framed Panels - Monogram FZIR360NNRH Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions - Standard Installation

STEP 9 INSTALL FRAMED PANELS

Install Door Panel:
• Open the door to 90°.
• Remove the 12 screws holding the trim, lift off the trim.
Retain the screws.
• Slide the framed panel into the door trim.
STEP 9A INSTALL FRAMED PANELS
Install Door Panel:
• Open the door to 90°.
• Remove the 12 screws holding the trim, lift off the trim.
Retain the screws.
• Slide the overlay panel into the door trim.
Use Front Holes
to Secure Trim
Use Rear Holes
to Secure Visor Handle
from Optional Kit ZKLN
Use Front Holes
to Secure Visor
Handle from Optional
Kit ZKLN
Use Rear Holes
to Secure Trim
Right hand models shown. Use the same instructions
for left hand models.
IF YOU ARE INSTALLING OVERLAY PANELS,
GO TO STEP 9A.
Door Trim
• There are two sets of holes in the handle side trim.
Replace the handle side trim by installing the original
screws in ALL screw holes.
Right hand models shown. Use the same instructions
for left hand models.
IF YOU ARE INSTALLING OVERLAY PANELS,
GO TO STEP 9A.
Door Trim
• There are two sets of holes in the handle side trim.
Replace the handle side trim by installing the original
screws in ALL screw holes.
Custom Handles
If you are using custom handles, the handle must be
properly secured to the panel before sliding the panel into
the trim.
• The cabinet manufacturer will supply the custom handle
and hardware.
20
Door
Door
31-1000416 Rev. 0

Publicidad

Tabla de contenido
loading

Tabla de contenido