Step 9 Install Grille Panel; Step 10. Install 1/4" Framed Panels - Monogram ZIP360NN Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation Instructions - Standard Installation

STEP 9 INSTALL GRILLE PANEL

• Raise the access panel to the stop position.
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
• Slide the panel over the metal baker panel and into the
trim.
• If necessary, tap with a wood block until the panel slips
under the top trim piece.
STEP 10 INSTALL 1/4" (0.63 cm) FRAMED
PANELS
Use rear holes to
secure trim
Install door and drawer panels:
• Open door to 90°. Remove the 8 Phillips head screws
from the door trim.
• Remove trim. Retain all screws.
• Slide framed panel into the door trim.
• Reassemble the bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
IF YOU ARE INSTALLING OVERLAY PANELS,
GO TO STEP 10A.
Door Trim
Refrigerator Door
• Secure the trim to the door using the screws removed
earlier.
• Follow the same procedures to install the second door
panel.
• For freezer drawer, once panel is installed, use all 8
screws holes to install the door trim.
20
31-1000451 Rev. 0

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Zips360nnss

Tabla de contenido