LaCimbali Q10 Manual De Uso Y Instalación página 55

This function can be activated in various ways:
1) setting the desired number at the repeats entry in the
beverage recipe (see CLIENT PROGRAMMING and
paragraphs referring to Key Menu). .
1RWH: To have access to customer programming,the function
must have been previously enabled by the installer "Technician
SURJUDPPLQJ&RQ¿JXUDWLRQ&XVWRPHU SURJ <(6".
2) Press any one of the selection keys and after about 3
seconds press the same key again for the number of
dispensed drinks required.
The machine is equpped with a software program that makes
it possible to quickly change the coffee dose without needing
the technician's assistance.
Note: This function is possible ONLY if the entry "EHDQ NH\",
LQ WKH WHFKQLFDO FRQ¿JXUDWLRQ PHQX KDV EHHQ VHW WR ³<(6´ E\
the installer.
To modify the coffee dose, access the programming key (Tp)
and press the "bean" key
on the display:
À CUSTOMER PROG.
KEY MENU
Press the key (32) for which you want to vary the coffee dose.
The following will appear on the display:
001 cof. dose
-5

Use the "+" () and "-"
6(/(&7,21 5(3(7,7,21 )XQFWLRQ
&RIIHH GRVH YDULDWLRQ
(%.). The following will appear
064
064 +5
+
(31) keys to set the number.
1RWH: This second mode can be used only if the "Technician
SURJUDPPLQJ&RQ¿JXUDWLRQ'LVSHQVLQJ 6WRS 12" WAS
NOT enabled by the installer.
The number of dispensed drinks programmed is indicated on
the top left of the display. Press the
for about 3 sec. to reset.
127(. These functions are deactivated when error messages
and/or codes are displayed and the item "Technician program-
ming/&RQ¿JXUDWLRQ/3URJUDP EORFN" is set on "YES".
32
The dose set for both grinders in the technician programming
menu can vary by ±5.
Example
7HFKQLFLDQ SURJUDPPLQJ
Coffee dose MM1 
Coffee dose MM2 
To exit the panel, press the key
made to the numbers or press the 5(6 () key
the settings as is.
53
key and keep pressed
Tp
%.
32
&XVWRPHU SURJUDPPLQJ
Coffee dose MM1 ·
Coffee dose MM2 ·
WR FRQ¿UP DQ\ FKDQJHV
to leave