Chapter 2. Transport And Installation - gala gar GALA MIG 257 Manual Técnico De Instrucciones

2. TRANSPORT AND INSTALLATION.
Knocks and sudden movements must be avoided when transporting the equipment. The equipment will always be
transported vertically. The packaging must be protected from water.
6º
The welding equipment location must meet the following requirements:
- Place: Dry and ventilated, far enough away from the cutting area in order to prevent the metal dust caused
by the cutting process from getting into the equipment.
Electrical installation. Magnetothermal switch (Curve "D")
Power supply hose (RVK-1KV).
When leaving the factory the equipment is labelled with the voltage of use which has been chosen internally. In
dual-voltage three-phase equipment, the voltage can be changed on the inside of the equipment. Remove the
side panel. On the inside you will find a connection card (this is protected with a plastic cover). Make the
connection of the machine as indicated in Figure.
STANDARD EQUIPMENT (230/400 V)
3º
2º
4º
5º
3P 16 A -
230V
Length
10 m
15-20 m
Voltage change system.
230 V
400 V
GALA MIG 257.
Wheels assembling.
1º
7º
.
GALA MIG 257
3P 10 A -
400V
GALA MIG 257
230 V 400 V
2
1,5 mm 1,5 mm
2,5 mm 2 2,5 mm
SPECIAL EQUIPMENT (220/440 V)
8º
9º
10º 10º
2
2
11