Sime Format Instrucciones Para El Instalador página 96

The display then changes to the further
programme. Repeat the same opera-
tions to set the successive programmes.
At the end of the programming. Move the
selector to the "RUN" position.
– Cancelling one or more
programmes (fig. 7)
The programmed switch-on time and
switch-off time must be cancelled for
each individual programme by moving
selector (2) to the "P" position.
Select the required programme with but-
ton (3), press button (4) to cancel the
settings for that day (the triangular day
indicator should disappear).
If a part of the programme is cancelled,
when selector (2) is returned to the
"RUN" position, an error message will
appear on the clock display together with
an indication of the incorrect program-
me. To cancel all the programmes, move
94
the selector to the "P" position and press
buttons (3) and (5) simultaneously.
– Setting the "SKIP" function (fig 7)
The SKIP function defused the program-
mes when going out for the day, during
which no heating is required.
To start this function, press button (7);
the button is only active when selector (2)
is in the "RUN" position.
Once selected, the SKIP function beco-
mes active at 0:00 of the following day
and lasts for 24 hours.
Once activated, it cannot be defused.
Consequently the normal programme
will only be resumed after 24 hours.
KEY
1 Manual/automatic operation selector
2 Programmer/timer setting selector
3 Programme button
4 Day button
5 Hour button
6 Minute button
7 SKIP function button
8 Reset button
Fig. 6
Fig. 7