Transport; Assembly Instructions; Delivery Conditions; How To Assemble The Handlebar.adjustable Position - Sima COBRA-40 Manual De Instrucciones

USE SAFETY GLOVES

3. TRANSPORT

For short distances, the floor saw COBRA 40 can be transported onto its own wheels. Raise the blade fully and
move the saw manually.
When the machine must be lifted, use the hook located on the front part. It will be then easy to fix steel cables or
chains. (See figure 2). Its weight and dimensions make it easy to transport in small vehicles.
WARNING: use highly- resistant cables or chains (bear in mind the weight of the machine and see the metal plate
of the machine).
When the machine will be lowered, do it gently and avoid any strong bumps on the wheels that could damage the
components. Elevate the machine where indicated by the arrow fig. 2.

4. ASSEMBLY INSTRUCTIONS

A. DELIVERY CONDITIONS
The different versions of floor saws model COBRA 40/45 are supplied and single packed into reinforced cardboard
boxes onto a wooden pallet.
With the machine, the operator will find the following components:
x Steel chassis of the machine without blade and with the handlebar removed.
x Handlebar.
x a plastic bag containing a small lever for the adjustable blade wheel, a 4mm Allen key as well as an envelope
with operator manual, the warranty voucher and engine manual.
B. HOW TO ASSEMBLE THE HANDLEBAR.ADJUSTABLE POSITION
The handlebar is dismantled when the machine is delivered because it is easy to fit and also to avoid too much
packaging. To fix it, remove the screws and washers (T, Fig.3) from the chassis of the machine. Place the handlebar (M,
Fig.3) onto the chassis as shown on figure 3 and tighten the screws.
The handlebar of the floor saw COBRA-40/45 has been designed to be adjusted to different types of operators.
How to adjust the handle? Loosen the screws (do not remove them) (T, Fig.4) and use the spanner supplied with
the machine. Use the groove and push manually. The handle will rotate along the screws until it reaches a desired and
comfortable position for the operator. Tighten again the screws. (See Figure 4).
C. HOW TO ASSEMBLE THE DEPTH CRANK
The adjustable depth crank (M, Fig.5) is supplied without the small handle assembled (T, Fig.5) for packaging
reasons and to avoid any breakages during the transport. It is easy to fit: thread it to the crank and use the Allen key 4
mm (A, Fig.5) supplied with the machine.
D. HOW TO PLACE THE BLADE
A good choice ensures performance and improves final results.
Blades must be cooled. Accordingly the floor saw COBRA 40/45 has a water spray system that ensures a steady
stream of water.
USE SAFETY FOOTWEAR
6
ENGLISH