Festo EGC-BS-KF Instrucciones De Utilizacion página 26

EGC-BS-KF, EGC-HD-BS
Interfaces for mounting components
on the cover
e.g. with foot mounting HPE
(only for EGC-...-BS-KF)
1) è www.festo.com/catalogue
Tab. 1
Note
Danger of screws being pulled out if the axis is only mounted to the covers and the
torque load around the longitudinal axis is too great.
• If there are heavy loads, mount the axis to the profile with additional mounting
components.
• Tighten all of the mounting screws to the same tightening torque according to the following table.
Size
Screw (cover)
Tightening torque
Tab. 2
Fitting in a vertical or sloping position:
Warning
Injury to people and damage to property.
If there is a power failure or if the spindle nut
breaks, the work mass will fall.
• Make sure that you only use motors with an
integrated spring-loaded holding brake.
• Check whether additional external safety
measures to protect against spindle nut frac­
ture are necessary (e.g. toothed latches, mov­
ing bolts or emergency buffers).
26
on the profile
1)
e.g. with slot nuts NST
70
M5
[Nm] 5,9
1)
e.g. with profile mounting MUE
80 120
M5 M8
5,9 24
Fig. 5
Festo – EGC-BS-KF, EGC-HD-BS – 1505e English
1)
185
M10
47