Laser Devices; Important Notice - BZ-TECH D-6448 Manual De Instrucciones

For CE-Countries
It is in conformity with the CE standards. Please note that a CE-Marked power supply unit
should be used to conform to these standards.

Laser Devices

The devices using lasers comply with US 21CFR1040.10 and 1040.11 except for deviations
pursuant to Laser Notice No. 50 dated July 26, 2002 and IEC608525-1:+A1:1997+A2:2001
The laser classification is marked on one of the labels on the devices.
Class 1 Laser devices are not considered to be hazardous when used for their intended purpose.
The following statement is required to comply with US and international regulations:
Caution: Use of controls, adjustment or performance of procedures other than those specified
herein may result in hazardous laser light exposure.
Class 2 laser scanners use a low power, visible light diode. As with any bright light source, such
as the sun, the user should avoid staring directly into the light beam. Momentary exposure to
a Class 2 laser in not known to be harmful.

Important Notice

1. This document is in A5 size. Please check your printing setting before printing it out.
2. When printing barcodes for programming, the use of a high-resolution laser printer is
strongly suggested for the best scan result.
3. The settings shall be updated periodically without prior notice. For the latest version, please
contact your authorized distributor.
Settings and Programming
Scan a series of selected barcode patches in this manual to affect setup and programming of
your handheld 2D Image Reader. Decoding options and interface protocols can be tailored to
a specific application. Setup parameters are stored in non-volatile memory in the scanner and
are retained even when power is off. Setup parameters change only when you reset them.
Throughout the programming guide, default values are indicated with square.
You may need to hide adjacent code patches with your hand when scanning.
Programming Options
This section contains the following two divisions:
• Default factory device settings.
• Supported symbologies.