BZ-TECH D-6448 Manual De Instrucciones página 246

Programming Guide S-100W - Ver. 1.0
Enable 978 Supplemental
Mode
Enable Smart Supplemental
Mode
UPC/EAN/JAN Supplemental Redundancy
With Auto discriminate UPC/EAN/JAN Supplemental selected, this option adjusts the number
of times a symbol without supplemental is decoded before transmission. The range is from two
to thirty times. Five or above is recommended when decoding a mix of UPC/EAN/JAN symbols
with and without supplemental, and the auto discriminate option is selected. The default is set
at 10.
Scan the bar code below to set a decode redundancy value. Next, scan two numeric bar codes
in Appendix D, Numeric Bar Codes. Single digit numbers must have a leading zero. To correct
an error or change a selection, scan Cancel.
UPC/EAN/JAN
Supplemental Redundancy
Transmit UPC-A Check Digit
The check digit is the last character of the symbol used to verify the integrity of the data. Scan
the appropriate bar code below to transmit the bar code data with or without the UPC-A check
digit. It is always verified to guarantee the integrity of the data.
Transmit UPC-A Check Digit
Do Not Transmit UPC-A Check Digit
245