Symbologies - BZ-TECH D-6448 Manual De Instrucciones

Programming Guide S-100W - Ver. 1.0

Symbologies

Introduction
This chapter describes symbology features and provides the programming bar codes for
selecting these features. Before programming, follow the instructions in Chapter 1, Getting
Started.
The device is shipped with the settings shown in the Symbology Default Table If the default
values suit requirements, programming is not necessary.
There are two ways to change a parameter value:
• Scan the appropriate bar codes in this guide. These new values replace the standard default
values in memory.
• For SSI and USB SNAPI hosts, send a "parameter send" command from the host system.
Hexadecimal parameter numbers are shown in this chapter below the parameter title, and
options are shown in parenthesis beneath the accompanying bar codes. See the Simple Serial
Interface (SSI) Programmer's Guide for detailed instructions for changing parameter values
using this method.
Note: Most computer monitors allow scanning the bar codes directly on the screen. When
scanning from the screen, be sure to set the document magnification to a level where the bar
code can be seen clearly, and bars and/or spaces are not merging.
To return all features to default values, scan the Set Default Parameter bar code. Throughout
the programming bar code menus, default values are framed.
235