Publicidad
Idiomas disponibles
Idiomas disponibles
Programming Guide S-100W - Ver. 1.0
2. Look up the keystroke desired for FN1 Substitution in the ASCII Character Set table for
the currently installed host interface. Enter the 4-digit ASCII Value by scanning each digit in
Appendix D, Numeric Bar Codes.
To correct an error or change the selection, scan Cancel. To enable FN1 substitution for USB
HID keyboard, scan the Enable FN1 Substitution barcode.
Transmit "No Read" Message
Scan a bar code below to select whether or not to transmit a No Read message. When enabled,
the characters NR are transmitted when a bar code is not decoded. When disabled, if a symbol
does not decode, nothing is sent to the host.
Enable No Read
Disable No Read
Maintenance
Cleaning the scan window is the only maintenance required. A dirty window may affect
scanning accuracy.
Never use any abrasive material or solvents on the window. Do not spray water or other
cleaning liquids directly onto the window.
Remove dirt by wiping gently with a damp cloth or tissue moistened with water and/or ammonia.
298
Publicidad
Capítulos
