BZ-TECH D-6448 Manual De Instrucciones página 198

Programming Guide S-100W - Ver. 1.0
*In the Nixdorf Mode B, if CTS is Low, scanning is disabled. When CTS is High, the user can
scan bar codes.
**If Nixdorf Mode B is scanned without the decoder connected to the proper host, it may
appear unable to scan. If this happens, scan a different serial host type within 5 seconds of
cycling power to the decoder.
Selecting ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS/JPOS,
Olivetti, or Omron enables the transmission of code ID characters listed in table below. These
code ID characters are not programmable and are separate from the Transmit Code ID feature.
Do not enable the Transmit Code ID feature for these terminals.
Terminal Specific Serial
197