Descargar Imprimir esta página

BZ-TECH D-6448 Manual De Instrucciones página 255

Publicidad

Idiomas disponibles

Idiomas disponibles

Programming Guide S-100W - Ver. 1.0
Code 32 Prefix
Scan the appropriate bar code below to enable or disable adding the prefix character "A" to
all Code 32 bar codes.
Note: Convert Code 39 to Code 32 must be enabled for this parameter to function.
Enable Code 32 Prefix
Disable Code 32 Prefix
Set Lengths for Code 39
The length of a code refers to the number of characters (i.e., human readable characters),
including check digit(s) the code contains. Set lengths for Code 39 to any length, one or two
discrete lengths, or lengths within a specific range. If Code 39 Full ASCII is enabled, Length
within a Range or Any Length is the preferred options.
Note: When setting lengths for different bar code types by scanning single digit numbers, single
digit numbers must always be preceded by a leading zero.
• One Discrete Length - Select this option to decode only Code 39 symbols containing a selected length.
Select the length using the numeric bar codes in Appendix D, Numeric Bar Codes. For example, to decode
only Code 39 symbols with 14 characters, scan Code 39 - One Discrete Length, then scan 1 followed by 4.
To correct an error or change the selection, scan Cancel barcode.
• Two Discrete Lengths - Select this option to decode only Code 39 symbols containing either of two
selected lengths. Select lengths using the numeric bar codes in Appendix D, Numeric Bar Codes. For
example, to decode only those Code 39 symbols containing either 2 or 14 characters, select Code 39 - Two
Discrete Lengths, then scan 0, 2, 1, and then 4. To correct an error or change the selection, scan Cancel
barcode.
• Length Within Range - Select this option to decode a Code 39 symbol with a specific length range.
Select lengths using numeric bar codes in Appendix D, Numeric Bar Codes. For example, to decode Code
39 symbols containing between 4 and 12 characters, first scan Code 39 - Length Within Range. Then scan
0, 4, 1, and 2 (single digit numbers must always be preceded by a leading zero). To correct an error or
change the selection, scan Cancel barcode.
• Any Length - Select this option to decode Code 39 symbols containing any number of characters within
the decoder capability.
254

Publicidad

loading

Productos relacionados para BZ-TECH D-6448