Publicidad
Idiomas disponibles
Idiomas disponibles
Programming Guide S-100W - Ver. 1.0
Image Capture Illumination
Selecting Enable Image Capture Illumination causes the decoder to flash on every image
capture. Select Disable Illumination to prevent the decoder from using artificial illumination.
Enabling illumination usually results in superior images. The effectiveness of the illumination
decreases as the distance to the target increases.
Enable Image Capture Illumination
Disable Image Capture Illumination
Gain
This parameter only applies when Decoding or Image Capture Auto exposure is disabled. Gain
is a means of amplifying the raw image data before it is converted into 256 grayscale values.
Increasing the gain increases brightness and contrast, but also increases noise (undesired
electrical fluctuations in the image) which makes the image less attractive and/or harder to
decode.
To set the manual gain, scan the bar code below followed by 3 bar codes from Appendix D, Numeric
Bar Codes, in the range of 79 to 127, representing the value. The default is 100.
Set Gain
183
Publicidad
Capítulos
