Moving The Heater Controls From One Side To The Other - Helo VIENNA STS Instalación Y Manual De Uso

Product Manual Vienna STS
Quality stones meet the following requirements:
- Sauna stones should withstand heat and heat variation caused by vaporisation of the water thrown on the
stones.
- Stones should be rinsed before use in order to avoid odour and dust.
- Sauna stones should have an uneven surface to supply a larger surface for the water to evaporate from.
- Sauna stones should be large enough, measuring about 50–80 mm to allow good ventilation between the
stones. This extends the useful life of the heating elements.
- Sauna stones should be piled sparsely in order to enhance ventilation between the stones. Do not bend
the heating elements together or against the frame.
- Rearrange the stones regularly (at least once a year) and replace small and broken stones with new, lar-
ger stones.
- Stones are piled so that they cover the heating elements. Do not, however, pile a large heap of stones on
the heating elements. Please refer to the table on page 8 . Table 1 for an adequate amount of stones. Any
small stones in the package of stones mustn't be piled on the sauna heater.
- The warranty does not cover defects resulting from poor ventilation caused by small and tightly packed
stones.
- Structural clay tiles are not allowed. They may cause damage to the sauna heater that will not be covered
by the warranty.
- Do not use soapstone as sauna rocks. Any damages resulting from this will not be covered by the stove
warranty
- Do not use lava stone as sauna rocks. Any damages resulting from this will not be covered by the stove
warranty
-
DO NOT USE THE HEATER WITHOUT STONES.

2.5 Moving the heater controls from one side to the other

By default, the thermostat and the timer switch are located
on the left hand side of the heater when viewed from the
front. They can be moved to the other side, if necessary.
The work may only be carried out by a qualified electrician.
1. Turn the heater upside down. Unfasten the bottom plate.
2. Pull off the dials for the thermostat and the timer switch.
Unfasten the two screws in the thermostat and timer
switch frame. Remove the plastic covers for the electric
box and the outer shell from the back. Move the thermostat,
the timer switch and their frame to the other side and
refasten using two screws. Insert the plastic covers in the
now empty holes.
Push the thermostat and timer switch dials back into place.
NOTE! Leave a minimum of 1 mm between the dial and the
heater outer shell.
3. Fasten the bottom plate, install the heater and check that it works.
4
2
3
1
5
1. Thermostat
2. Timer switch
3. Dial
4. Temperature limiter reset
5. Outer shell of the heater
5
5
1
3
2
4