Installation and User Manual
1. VARNINGAR
1.1. Check before taking a sauna bath
1.
The sauna room is suitable for taking a sauna bath.
2.
The door and the window are closed.
3.
The sauna heater is topped with stones that comply with the manufacturer's
recommendations, the heating elements are covered with stones, and the stones
are piled sparsely.
The main switch of the heater is located on the side of the contactor box
The main switch is marked with a 0 – 1 sticker.
1.2. Sauna room
The walls and ceiling of a sauna room should be thermally well insulated. All surfaces that store
heat, such as tiled and plastered surfaces must be insulated. It is recommended to use wooden
panel cladding inside the sauna room. If there are heat storage elements in the sauna room,
such as decorative stone, glass etc., note that these elements may extend the pre-heating period
even though the sauna room is otherwise well insulated (see page 4, section 2. Preparing for
sauna heater installation).
1.3. Information for use
This appliance may not be used by children aged less than eight years, by persons with reduced
physical, sensory or mental capabilities, or by persons lacking experience and knowledge
regarding its operation only if such have been given instructions on the safe use of the device
and the risks involved. Children must not be allowed to play with the appliance or to clean and
service it without supervision. (7.12 EN 60335-1:2012)
1.4. Operation of the sauna heater controls
Refer to the specific control panel operating instructions.
Rearrange the sauna stones at least once a year and replace any weathered stones. This
enhances air circulation between the stones, which extends the useful life of the thermal
resistors.
If you encounter any problems, please contact the manufacturer's warranty service shop.
For additional information about enjoying a sauna bath, please visit our website at :
www.tylohelo.com
MAGMA
SKLA
and
3