Kit Assembly - Metra 99-8223 Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Attach the clips removed from the
factory radio to the back of the radio
housing trim plate. (Figure A)
2. Slide the radio housing brackets onto
the sides of the radio housing until the
side clips engage. Note, tabs are marked
Left and Right. (Figure B)
3. Mount the ISO brackets to the radio
using the screws supplied with the
radio. (Figure C)
4. Slide the radio into the radio housing
until it snaps into place. (Figure D)
5. Snap the trim plate onto the front of the
radio housing. (Figure D)
6. Locate the factory wiring harness in
the dash. Metra recommends using
the proper mating adapter from Metra
or AXXESS. Re-connect the negative
battery terminal and test the radio for
proper operation.
7. Reassemble dash in reverse order
of disassembly.
99-8223

Kit Assembly

(Figure A)
(Figure C)
(Figure B)
(Figure D)
3
Right side clip