Kit Assembly - Metra 99-6504 Instrucciones De Instalación

Dash Disassembly
Jeep Wrangler 2003-2006
1. Unsnap and remove defroster grille
panel near windshield. (Figure A)
2. Remove (2) Phillips screws
exposed at the top of the center
dash panel and unsnap and
remove panel.
3. Remove glove box door to access
one 10mm nut on back of radio.
4. Remove (4) Phillips screws
securing radio. Disconnect and
remove radio.
Continue to kit assembly
(Figure A)
®
99-6504
ISO DIN radio provision with pocket
1. Attach the ISO brackets to the
radio housing by sliding the
bracket tabs into the housing slots.
(Figure A)
2. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
3. Slide the radio into the radio housing.
4. Align the holes in the radio with
the holes in the ISO brackets and
mount the radio to the brackets
with the screws supplied with the
radio. (Figure B)
5. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections
to the radio. Metra recommends
using the proper mating adapter from
Metra and/or AXXESS. Test the radio
for proper operation .
6. Reassemble the dash in reverse
order of disassembly.
6

Kit Assembly

(Figure A)
(Figure B)