Geo Storm/Isuzu Impulse 1990-1993
Isuzu Stylus 1991-1993
1. Remove the ashtray and the (2)
outermost screws exposed in the
ashtray cavity. Remove (2) screws from
each side of the dash console. Remove
the climate control knobs. Unclip the
radio trim bezel. (Figure A)
2. Remove (4) screws from the metal
console support.
3. Remove the factory head unit assembly
and disconnect the wiring.
4. Remove (4) screws securing the factory
spacer plate to the radio brackets and
remove the plate.
5. Cut and remove all mounting tabs
on brackets set #2 except tabs "C".
(Figure B)
6. Using the v-cut as a guide cut and remove
the bottom portion of the radio housing.
7. Mount the brackets to the housing with
(4) #6 Phillips screws supplied.
8. Mount the factory pocket to the
brackets through holes "A" with (4)
#8 Phillips screws supplied (it may be
necessary to trim the top and bottom
edges of the pocket for a proper fit).
(Figure C)
9. Slide the factory spacer plate onto the
brackets and mount through holes "B"
with (2) Phillips screws and (2) speed
clips supplied. (Figure C)
Continue to kit assembly
Dash Disassembly 99-3400
(use if keeping factory pocket)
(Figure A)
"C"
(Figure B)
"A"
"B"
(Figure C)
7
"C"
"C"
"C"
"A"
"B"