Kit Assembly; Din Radio Provision With Pocket; Iso Din Radio Provision With Pocket - Metra 99-6505 Instrucciones De Instalación

DIN radio provision with pocket

1. Remove the metal DIN sleeve from
the aftermarket radio.
2. Slide the sleeve into the assembly
and secure by bending the metal
locking tabs down. (Figure A)
3. Slide the radio into the sleeve until
secure. (Figure B)
4. Locate the factory wiring harness
and antenna connector in the
dash and make all necessary
connections to the radio. Metra
recommends using the proper
mating adapters from Metra and/
or AXXESS. Reconnect the negative
battery terminal and test the radio
for proper operation.
5. Reassemble the dash in reverse
order of disassembly.

Kit Assembly

(Figure A)
(Figure B)
99-6505

ISO DIN radio provision with pocket

1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
2. Align the holes in the ISO snap-in
brackets with the holes in the
radio and mount the brackets to
the radio with the screws supplied
with the radio. (Figure A)
3. Slide the radio/bracket assembly
into the radio opening until the side
clips engage. (Figure B)
4. Locate the factory wiring harness
and antenna connector in the
dash and make all necessary
connections to the radio. Metra
recommends using the proper
mating adapters from Metra and/
or AXXESS. Reconnect the negative
battery terminal and test the radio
for proper operation.
5. Reassemble the dash in reverse
order of disassembly.
7
(Figure A)
(Figure B)