Kit Assembly - Metra 99-7807 Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Mount the (2) factory clips to the
radio housing. (Figure A)
2. Mount the climate switches to the
radio housing using (6) of the
#8 x 1/2" screws on the upper
and outside mounts. Do not install
the screws on the bottom mounts
shared by the radio brackets
until installing the radio/bracket
assembly. (Figure A)
3. Mount the pocket to the brackets
with the (4) #8 x 3/8" Phillips
screws supplied. (Figure B)

Kit Assembly

(Figure A)
(Figure B)
99-7807
4. Slide the radio into the brackets
and secure with screws supplied
with the radio. (Figure C)
5. Mount the radio assembly to
the radio housing with (4) of the
supplied #8 x 1/2" screws.
(Figure D)
6. Locate the factory wiring harness
and antenna plug in the dash.
Metra recommends using the
proper mating adapters from
Metra and AXXESS.
7. Mount the new radio assembly into
the dash and reassemble dash in
reverse order of disassembly.
6
(Figure C)
(Figure D)