Publicidad
Idiomas disponibles
Idiomas disponibles
1. Mount the ISO Brackets to the radio using the
screws supplied with the radio. (Figure A)
Note: You will need to remove the aftermarket
radio's trim ring if equipped.
2. Slide the radio into the opening until it snaps into
place. (Figure B)
(Figure A)
Kit Assembly 99-6507
ISO radio provision with pocket
3. Using the alignment pins on the trim plates & the
corresponding holes in the housing, attach the
upper trim plate and the lower trim plate supplied
with the kit. (Figure B)
4. Locate the factory wiring harness in the dash.
Metra recommends using the proper mating
Upper
trim plate
Lower
trim plate
(Figure B)
11
adapter from Metra or AXXESS. Re-connect the
negative battery terminal and test the unit for
proper operation.
5. Reassemble dash in reverse order
of disassembly.
Publicidad
Capítulos
