Cd/Mp3 - auna 10032936 Manual De Instrucciones

CD/MP3

Discs for Playback
This system can playback all digital audio CD/MP3, finalized digital audio
CD-Recordable (CD-R) discs, finalized digital audio CD-Rewritable (CD-RW)
discs and CD-DA format digital audio CD/CD-R/CD-RW discs.
LOADING A DISC
• Press the Function selection button (15) on unit or the FUNC key (1) on
remote control to select "CD" mode.
• Press the PUSH TO OPEN button to open the CD door, "OP" will be
shown on the display.
• Place an audio CD/MP3 DISC into the tray with the front side facing up.
• Close the CD door.
• The display will show a flashing "READING", then the total number of
tracks would be shown and the playback will start from track.
• To remove the CD, press Stop button
press the PUSH TO OPEN button to open the CD compartment lid. Hold
the CD by its edges, and take it out carefully.
Note: Make sure the disc is stopped before opening the CD door (11). To
ensure good system performance, wait until the unit completely reads
the disc before proceeding. If no disc loaded into the tray, or the disc is
unreadable, the display will show "NO".
Playing a disc
• To pause playback, press
Pause key (7) on remote control, the current playing time will flash on
the display. To resume playback, press
unit or Play/Pause key (7) on remote control again.
• To stop playback, press Stop button
control.
Selecting a desired track/passage
To select a desired track:

• Press the FORWARD oder
playing until the desired track appears on the display. It will start play
automatically.
(14) to turn off the unit, then
Play/Pause button (16) on unit or
Play/Pause button (16) on
(14) on unit or (9) on remote

BACK button on stop mode or during
Play/
EN
27