Radio - auna 10032936 Manual De Instrucciones

EN
26

RADIO

Tuning radio stations
1 Press the Function selection button (15) on unit or the FUNC key (1) on
remote control to select the radio mode: FM.
2 Tune to desired station by rotating the Tuning knob (17) on unit, the
display will show the band frequency. Example: FM 97.10 MHz. You
can also press and hold the
searching, it will auto stop at any station with strong signal.
3 Rotate the Volume knob (6) on unit to increase or decrease volume.
4 Extend the telescopic antenna (22) to its full length and gently move
the unit back and forth to get the best reception, or place the unit in an
open location.
5 To turn off the radio, press the Function selection button (15) on unit or
the FUNC key (1) on remote control to switch to other functions or press
Standby button (8) on unit or STANDBY key (16) on remote control to
turn off the unit.
Auto preset memory / scan
• To search for and automatically save stations to preset memory, press
and hold the Play button (16) on unit. Any station with a strong enough
signal will be saved to preset memory. After the unit finishes scanning,
the unit will automatically tune to preset station number 1 (P01).
• To tune to the next or previous preset station, press FOLD./10/M.+/-
button (4 & 5) on unit or FOLD./10/M. (UP/DOWN) key (5) on remote
control.
Manual preset memory operation
You may pre-store 30 radio stations in memory for your preference.
1 Rotate the Tuning knob (17) on unit to select the desired station that you
want to save as a preset.
2 Press the PROG./P-MODE/MEM. button (7) on unit or press MEM key
(3) on remote control, "P01" will flash on the display to indicate that
you are saving the station as preset memory 01. To change the preset
memory sequence, press the FOLD./10/M +/- button (4 & 5) on unit
or FOLD./10/M (UP/DOWN) key (5) on remote control, then press
PROG./P-MODE/MEM. button (7) on unit or press MEM key (3) on
remote again to enter.
3 Search another station, repeat steps (1) and (2) until all desired stations
stored. Up to 30 FM stations can be programmed.
4 Press the FOLD./10/M +/- button (4 & 5) on unit or FOLD./10/M (UP/
DOWN) key (5) on remote control to switch between the stored
stations.
 
FORWARD or BACK button for fast