Husqvarna P 520D Manual De Usuario página 113

1. Set the lift lever for the cutting deck in the temporary
mow position (B).
B
A
WARNING: Do not put the lift lever to
mow position (A). Hydraulic force can
cause serious injury.
2. Carefully operate the product in front of the cutting
deck.
3. Make sure the lift arms attach into the joint of the
cutting deck.
4. Apply the parking brake.
5. Stop the engine.
6. Install the bolts (A) and attach the pins (B) on the lift
arms.
B
7. Remove the the 2 screws and remove the bottom
plate.
740 - 002 -
D
C
A
B
A
8. Pull back the coupling of the drive shaft and attach
the drive shaft to the power take-off.
Note: Make sure that the arrow on the symbol points to
the product.
9. Put the rear locking chain around the lift shaft.
10. Attach the locking chain to the drive shaft.
11. Pull back the coupling of the drive shaft and attach
the drive shaft to the shaft journal.
12. Fold the rubber casing above the shaft joint.
13. Put the locking chain around the cross pipe.
14. Attach the locking chain to the drive shaft.
15. Attach the bottom plate and tighten the screws.
16. Start the engine.
17. Set the lift lever for the cutting deck in the transport
position.
18. Stop the engine.
113