To Apply And Release The Parking Brake; To Stop The Engine; To Set The Power Outlet To On Or Off; To Get A Good Cutting Result - Husqvarna P 520D Manual De Usuario

• Adjust the airflow with the airflow adjuster (0-3).
• Engage (A) and disengage (B) the circulation throttle
with the circulation lever on the right side of the
steering wheel column.

To stop the engine

1. Park the product on level ground.
2. Apply the parking brake.
3. Push in the PTO button to disengage the drive on
the cutting deck.
4. Pull the hydraulic lift lever for the cutting deck
rearward to lift the cutting deck to transport position.
5. Move the throttle control forward to the MIN.
position.
122
6. Turn the ignition key to the OFF position (A).
A
To apply and release the parking
brake
B
1. To apply the parking brake, move the parking brake
lever fully forward.
2. To release the parking brake, move the parking
brake lever fully rearward.

To set the power outlet to on or off

• Press the power switch (A) on the right control panel
to set the power outlet (B) to on or off. The voltage of
the power outlet is 12 V. The power outlet has a
fuse, see

To get a good cutting result

• Do not cut a wet lawn. Wet grass can give a bad
cutting result.
A
Fuse overview on page 105 .
A
B
740 - 002 -