To Replace The Oil In The Bevel Gear Of The Cutting Deck; To Do A Check Of The Coolant Level - Husqvarna P 520D Manual De Usuario

To replace the oil in the bevel gear
of the cutting deck
1. Remove the cutting deck. Refer to
cutting deck on page 114 .
2. Put the cutting deck on its front edge and drain the
oil through the oil fill plug.
3. Let the oil run out into a container.
4. Fill with 80 ml new hydraulic oil as given in
data on page 142 .

To do a check of the coolant level

1. Park the product on level ground and stop the
engine.
2. Open the coolant cap.
3. Look down in the coolant tank.
4. Fill the coolant tank if you can not see the coolant
through the opening of the coolant tank. Refer to
Technical data on page 142 .
136
To remove the
Technical
740 - 002 -