Lubrication, General Information - Husqvarna P 520D Manual De Usuario

Quick maintenance guide
QUICK MAINTENANCE GUIDE
SAE 10W 50 API SM = 8L
Symbols on the quick maintenance guide
Replace the filter
Replace the oil
Examine visually or do a check of the oil
level
Lubricate the grease nipple with grease
Lubricate with engine oil
Do a check of the condition and tension of
the drive belt
740 - 002 -
First service after 25 hours
X-Variants
ANTIFREEZE = TIRE
50% Propylene Glycol PRESSURE = Front & Rear 1,5 bar
0,9L
3,0L
3,3L Front & Rear
TRANSMISSION OIL 10W 50 API SM
MOTOR OIL SAE 10W 40 API CP
Replace the drive belt

Lubrication, general information

• Remove the ignition key to prevent accidental
movements during lubrication.
• Use engine oil when you lubricate with an oil can.
• When you lubricate with grease, use a chassis or
ball bearing grease that prevents corrosion. Remove
unwanted grease after lubrication.
• Lubricate 2 times a week if you operate the product
daily.
• Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean with
alcohol. If the friction between the drive belt and the
pulley is not sufficient after you clean with alcohol,
replace the drive belt.
CAUTION: Do not use gasoline or other
petroleum products to clean drive belts.
SAE 80W/90 = 80cl (3oz)
137