To replace a low beam lamp
1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
3. Push the spring lock and remove the lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 142 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.
To replace a parking lamp
1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
3. Remove the lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 142 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.
To replace a turning lamp
1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
740 - 002 -
3. Turn the lamp counterclockwise and remove the
lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 142 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.
To replace the front working lights
1. Disconnect the cables from the broken lamp.
2. Turn the lamp counterclockwise and remove the
lamp.
3. Put the new lamp into the lamp housing. Refer to
Technical data on page 142 .
4. Connect the cables to the new lamp.
127