Set Up Requirements; What's In The Box; What You Need; Setting Up The Nursery Unit - Angelcare ACAM1 Manual Del Usuario

supply cords should be routed so that they are not
likely to be walked on or pinched by items upon or
against them, paying particular attention to cords
and plugs, convenience receptacle, and the point
where they exit from the product. The socket outlet
should be installed near the equipment and should
be easily accessible. Make sure to plug the adaptor
to the socket outlet nearest to the equipment and
that is easily accessible. To disconnect from mains,
unplug the adaptor
41. Only use attachments/accessories
and replacement parts specified by the
manufacturer. Any mounting of the product
should follow the manufacturer's instructions
• DO NOT position this product on an unstable cart,
stand, tripod, bracket or table. The product may fall,
causing serious injury to a child or adult and serious
damage to the product
• Use ONLY the stand sold with the product
• Be sure replacement parts are supplied by Angelcare
and have the same characteristics as original part.
Unauthorised substitution may result in fire, electric

SET UP REQUIREMENTS

WHAT'S IN THE BOX

Nursery Unit
1
Stand (for Nursery Unit)
2
AC Adaptor
3
Sensor Pad (on model ACAM2)
4
CR2450 Battery (for Sensor Pad)
5
(on model ACAM2)
Hardware (for wall mounting)
6

WHAT YOU NEED

Hardboard, if the cot does not have
a firm surface (for model ACAM2)

1- SETTING UP THE NURSERY UNIT

Sensor Pad
4
shock or fire
42. Unplug this appliance during lightning storms
or when not used for long periods of time
43. Servicing - DO NOT attempt to service
this product yourself as opening or removing
covers (except battery door) may expose you
to dangerous voltage or other hazards
• Power Supply – see Technical Specification within
this guide
44. Overloading - DO NOT overload wall outlets,
extension cords or integral convenience
receptacles as this can result in a risk of fire or
electric shock
45. Nursery Unit Antenna - The antenna used
for this transmitter must be installed to provide a
separation distance of at least 8'' (20 cm) from all
persons and must not be collocated or operating in
conjunction with any other antenna or transmitter
46. Cleaning - Disconnect all units before cleaning.
DO NOT immerse any part of the monitor in water.
Clean only with a dry cloth
1
4
Place the Nursery Unit
and Adaptor cord at
least 1 metre (3 feet)
from the cot
2
3
5
6
Wall-Mounted
1
Tabletop
2