Under The Cabinet Installation; Safety Warning - KOBE RA-038 Serie Instrucciones De Instalación Y Manual De Operación

Campana de extracción
Ocultar thumbs Ver también para RA-038 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SAFETY WARNING

HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES IF
REMOVING ANY PARTS FOR INSTALLING, CLEANING OR SERVICING.
NOTE: BE CAREFUL WHEN USING ELECTRICAL SCREWDRIVER, DAMAGE TO THE HOOD
MAY OCCUR.
Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE
VENT OPENING.
- Decide the location of the venting pipe from the hood to the outside. Refer to Figure 1.
- Temporarily wire the hood to test for proper operation before installing.
- Peel protective film off the hood (if any).
- For installing under the cabinets with recessed bottom, attach 4-inch wide wood filler
strips (not included) on each side. Refer to Figure 2.
- Measure and create access opening for electrical wires under the cabinet.
Hood Installation
CAUTION: If required to move the cooking range to install the hood, turn off the power on an
electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE.
1.
Puncture the knockout holes. Refer to Figure 3.

UNDER THE CABINET INSTALLATION

Figure 1
Figure 3
5
Figure 2

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Ra3830sqRa3836sq

Tabla de contenido