KOBE RA-038 Serie Instrucciones De Instalación Y Manual De Operación página 8

2. NOTE: Be careful when using electrical screwdriver, damage on the hood might occur.
Unscrew the six screws on the bottom casing. Remove the bottom casing as shown on
Figure 4. If necessary, arrange the electrical wire to run through the 1" diameter hole on
the hood.
3. Using references on Table 1 and measurement on page 16 center the hood in place
beneath the cabinet and flush with the front of the cabinet. Refer to Figure 5.
4. Draw electrical wires through cabinet access opening
5. Place screws (not provided) into the exact center of each hole. Make sure all screws are
in place before tightening screws. CAUTION: MAKE SURE THE HOOD IS SECURE
BEFORE RELEASING.
Ductwork Installation
6. Use aluminum or steel pipe to connect the plastic exhaust on the hood to the ductwork
above. Use duct tape to make all joints secure and air tight.
Wiring to Power Supply
7. Connect the electrical wires.
- If necessary to hide the electrical wire connections, push wires back into the hood.
Access the wire connections underneath the hood by removing the bottom casing from
the six screws. Before reattaching the bottom casing, make sure wires do not slip
between motors, impellers, or any moving parts to prevent any damage.
Figure 4
6
Figure 5