Össur FLEX-FOOT JUNIOR Instrucciones Para El Uso página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
FOOT COVER JRX50YYZ
Ensure the cover is completely inserted and the heel clip locks the foot
module into the cover. Seal the cover to avoid debris entering.
SHOE HORN CM100068
When removing and installing the cover use shoehorn to avoid damage
to foot or cover (Figure 6).
WEATHERPROOF
A weatherproof device allows use in a wet and/or humid environment
but does not allow submersion. Fresh water splashing against the
enclosure from any direction shall have no harmful effect. Dry thoroughly
after contact with fresh water. Fresh water: Includes tap water. Excludes
salt and chlorinated water.
LIABILITY
The manufacturer recommends using the device only under the specified
conditions and for the intended purposes. The device must be
maintained according to the instructions for use. The manufacturer is
not liable for damage caused by component combinations that were not
authorized by the manufacturer.
COMPLIANCE
This component has been tested according to ISO 10328 standard to two
million load cycles. Depending on the amputee's activity this
corresponds to a duration of use of two to three years. We recommend
carrying out regular yearly safety checks
ISO
Body mass limit not to be exceeded!
*)
For speci c conditions and limitations of use
see manufacturer's written instructions on
intended use!
the test loads have been adapted adequately on the basis of the specified
load level.
Category
1
2
3
• This manual is intended for use by a certified prosthetist.
- "P" - "m"kg *)
Weight (Kg)
24
34
45
In the standard mentioned,
test levels (P) are assigned to
a certain maximal body
masses (m in kg). In some
cases, which are marked with,
no test level is assigned to
the product related maximal
body mass. In these cases,
ISO10328
ISO 10328 -
ISO 10328 -
ISO 10328 -
P3
24
P3
34
P3
45
kg
kg
kg
6

Publicidad

Tabla de contenido
loading

Tabla de contenido