Boston Scientific LATITUDE 6280 Manual Del Paciente página 32

• If the LATITUDE indicator is not lit, check that
both ends of the AC adapter are plugged in
firmly. Check if the light on the AC adapter is lit.
Important: For the following steps, make sure
you use the Ethernet cable provided with the USB
Ethernet Adapter and not the telephone cord provided
with the Communicator.
3. Insert the standard (narrow) end of the USB cable
(included with the USB Ethernet Adapter) into one
of the USB ports on the Communicator labeled
.
4. Insert the square end of the USB cable into the
end of the USB Ethernet Adapter nearest the
adapter light.
5. Insert the Ethernet cable (included with the USB
Ethernet Adapter) into the opposite end of the
adapter.
6. Plug the Ethernet cable into an Ethernet port for
your internet service, such as a modem, router, or
Ethernet wall jack.
• The USB Ethernet Adapter is properly
connected if the green light in front is lit (solid or
flashing).
7. When the Heart button flashes, press it.
• Your Communicator's wave lights will flash
green in sequence and repeat for several
minutes as shown in "Using the Heart Button"
on page 37.
• If you have previously completed initial setup,
the Heart button will not flash at this point.
28
LATITUDE Communicator Patient Manual
TM