Connecting The Coarse Dirt Outlet; Connecting The Dirt Outlet; Connecting The Control System With Egc Box; Connecting The Control System - Oase ProfiClear Premium Compact EGC Instrucciones De Uso

- EN -
How to proceed:
 H
1. Undo the screws with a screwdriver and remove the sealing plugs.
2. Guide the outlet sockets of the Bitron with flat seals through the holes in the container wall.
3. Screw the adapters onto the outlet sockets and hand-tighten.
4. Screw the 30° inlet bends with cap nuts onto the adapters and hand-tighten.
– Position the inlet bends so that they are pointing downwards.
– Correctly positioned inlet bends prevent unintended overflow (emptying of the pond) and also serve
to reduce noise emissions.
5. Connect the Bitron to the filter pump in accordance with the operating manual.
Gravity fed system
The UVC clarifying unit Bitron Gravity is installed in the Individual Module. (→Please refer to the "Bitron
Gravity" and "ProfiClear Premium Individual Module" operating manuals.)
4.2.4

Connecting the coarse dirt outlet

 I
The coarse dirt that collects in the dirt channel drains away via the DN 110 coarse dirt outlet (top outlet
on the container) on the input side.
► Connect a suitable DN 110 pipe and drain the dirty water into the sewer system.
4.2.5

Connecting the dirt outlet

The water in the container can be drained via the DN 75 dirt outlet with slide valve at the bottom of the
container if required (for cleaning, repair, overwintering).
► Connect a suitable DN 75 pipe and drain the dirty water into the sewer system.
How to proceed:
 J
1. Remove the cap nuts and push the dirt outlet onto the connection.
2. Tighten the hose clip.
3. Tighten the cap nuts.
N O T E
Connect the DN 75 pipe to the DN 110 pipe for the coarse dirt, and drain the dirty water via a DN 110
pipe into the sewer system. This will ensure that the dirty water pipe will be conveniently flushed out with
sufficient pressure.
4.3

Connecting the control system with EGC box

4.3.1

Connecting the control system

For the pump fed system and for the gravity fed system, the cable harness contains the connection cables
of the signal box, drum motor and rinsing pump. These connection cables have to be connected, the EGC
box is already connected.
 K
► Connect the three connectors of the cable harness to the control system sockets. Hand-tighten the
union nuts.
– The connections are designed to prevent misconnection.
– First flood the container with water, then connect the control system to the mains voltage/power
supply.
50