BDA WMS 40 FLEXX 08_Hex:Layout 1
• If you use a rechargeable battery, the LED will switch to red 15 minutes before the bat-
tery will be dead!
If the status LED (16)/(23) fails to illuminate the battery is dead. Insert a new battery.
5. To close the battery compartment, slide the battery compartment lid (20)/(28) onto the
battery compartment from below to the point that the snap hook will engage.
1. Set the frequency selector (17) on the transmitter and the frequency selector (8) on the
receiver to the same positions (1 - 1, 2 - 2, or 3 - 3).
2. Set the SQUELCH control (14) on the receiver to minimum and switch power to the
receiver on.
3. To switch power to the transmitter on, set the on/off switch (16) to "ON".
4. Switch power to your sound system or amplifier on.
5. Talk or sing into the microphone, watching the AF LEDs (6) on the receiver.
• If the OK LED (6a) flashes rarely and the CLIP LED (6b) will not flash at all, the trans-
mitter input gain is too low. Set GAIN (18) to "HIGH".
• If OK (6a) is lit constantly and CLIP (6b) flashes frequently or is lit constantly, the trans-
mitter input gain is too high. Set GAIN (18) to "LOW".
6. Set the levels on your mixer or amplifier referring to the appropriate instruction manual,
or by ear.
1. Pull the color code clip (19) off the transmitter case in the direction of the arrow.
2. Slide the supplied semitransparent replacement clip onto the transmitter to the point
that it snaps into place with an audible click.
The PT 40 FLEXX bodypack transmitter has been designed for use with the CK 55 L, C 417
L, C 520 L, C 555 L, C 516 ML, C 518 ML. and C 519 ML microphones from AKG. If you
wish to connect other microphones from AKG or other manufacturers to the PT 40 FLEXX,
please note that you may have to rewire the existing connector on your microphone or re-
place it with a 3-pin mini XLR connector.
Audio input (24) pinout:
Pin 1: shield
Pin 2: audio inphase (+)
Pin 3: supply voltage
A 4-V positive supply voltage for condenser microphones is available on pin 3.
• Please note that AKG cannot guarantee that the PT 40 FLEXX bodypack trans-
mitter will work perfectly with products from other manufacturers, and any da-
mage that may result from such use is not covered by the AKG warranty scheme.
WMS 40 FLEXX
01/08/2008
15:52
3 Setting Up
Seite 29
(Schwarz/Black Auszug)
Note:
3.6 Setting Up
the Handheld Transmitter
Also refer to section 4 Micro-
phone Technique.
3.6.1 Replacing
the Color Code Clip
Refer to fig. 9 on page 2.
3.7 Setting Up
he Bodypack Transmitter
L
Important!
29