Setting Up The Handheld Transmitter; Replacing The Color Code Clip; Setting Up The Bodypack Transmitter - AKG WMS 40 FLEXX Modo De Empleo

3. Insert the supplied battery into the battery compartment conforming
to the polarity marks.
The transmitter will not function if you insert the battery the other way
round.
4. Set the on/off switch (15)/(22) to "ON" to switch power to the trans-
mitter on.
If the battery is in good condition, the status LED (16)/(23) will be lit
green.
If the status LED (16)/(23) is lit red, the battery will be dead within
about two hours. Replace the battery with a new one as soon as pos-
sible.
• If you use a rechargeable battery, the LED will switch to red 15 min-
utes before the battery will be dead!
If the status LED (16)/(23) fails to illuminate the battery is dead. Insert
a new battery.
5. To close the battery compartment, slide the battery compartment lid
(20)/(28) onto the battery compartment from below to the point that
the snap hook will engage.
1. Set the frequency selector (17) on the transmitter and the frequency
selector (8) on the receiver to the same positions (1 - 1, 2 - 2, or
3 - 3).
2. Set the SQUELCH control (14) on the receiver to minimum and switch
power to the receiver on.
3. To switch power to the transmitter on, set the on/off switch (16) to
"ON".
4. Switch power to your sound system or amplifier on.
5. Talk or sing into the microphone, watching the AF LEDs (6) on the re-
ceiver.
• If the OK LED (6a) flashes rarely and the CLIP LED (6b) will not flash
at all, the transmitter input gain is too low. Set GAIN (18) to "HIGH".
• If OK (6a) is lit constantly and CLIP (6b) flashes frequently or is lit con-
stantly, the transmitter input gain is too high. Set GAIN (18) to "LOW".
6. Set the levels on your mixer or amplifier referring to the appropriate in-
struction manual, or by ear.
1. Pull the color code clip (19) off the transmitter case in the direction of
the arrow.
2. Slide the supplied semitransparent replacement clip onto the trans-
mitter to the point that it snaps into place with an audible click.
The PT 40 FLEXX bodypack transmitter has been designed for use
with the CK 55 L, C 417 L, C 520 L, C 555 L, C 516 ML, C 518 ML. and
C 519 ML microphones from AKG. If you wish to connect other micro-
phones from AKG or other manufacturers to the PT 40 FLEXX, please
note that you may have to rewire the existing connector on your micro-
phone or replace it with a 3-pin mini XLR connector.
Audio input (24) pinout:
Pin 1: shield
Pin 2: audio inphase (+)
Pin 3: supply voltage
AKG WMS 40 FLEXX
3 Setting Up
Refer to fig. 8 on page 2.
Note:
3.6 S S etting U U p t t he
H H a a n n d d h h e e l l d d T T r r a a n n s s m m i i t t t t e e r r
Also refer to section 4
Microphone Technique.
3.6.1 R R eplacing t t he
Color C C ode C C lip
Refer to fig. 9 on page 2.
3.7 S S etting U U p t t he
B B o o d d y y p p a a c c k k T T r r a a n n s s m m i i t t t t e e r r
29