Operation In Detail - Klarstein Amazonia 10032678 Manual Del Usario

EN
40

OPERATION IN DETAIL

Starting the washing process
1 Pull out the basket.
2 Add a suitable detergent.
3 Insert the plug into the socket.
4 Press the POWER button to turn on the unit.
5 Connect the inlet hose to the faucet and make sure that the water supply is set to full
pressure OR manually add the water to the tank.
6 Select the desired program. When a program is selected, the corresponding
indicator will light up.
7 Press the START / PAUSE button to start the dishwasher.
Note: If you press the Start / Pause button to pause while washing, the program light
will stop flashing. The dishwasher will emit an audible alarm every minute until you
press the Start / Pause button again.
Changing the program
If possible, a running program should be changed directly after the start. Otherwise, the
detergent may have already dissolved and run out of the machine with the water. If this
is the case, refill with detergent. Press the START / PAUSE button to stop the machine.
With the door closed, hold down the button for more than three seconds to set the new
program.
Display
The display shows the status of the device or the run as follows:
Display Status
-:-- The device is in standby mode.
H:MM Display is not flashing: pause
H:MM Display is flashing: wash run is in progress
END The wash run has ended.