INSTALLATION
Preparation
• The installation position of dishwasher should be near the existing inlet and drain
hoses and power cord.
• One side of the cabinet sink should be chosen to facilitate the connection of drain
hoses of the dishwasher.
Positioning the Appliance
Position the appliance in the desired location. The back should rest against the wall
behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is
equipped with water supply and drain hoses that can be positioned to the right or the
left to facilitate proper installation.
Power Connection
Ensure the voltage and frequency of the power being corresponds to those on the rating
plate. Only insert the plug into an electrical socket which is earthed properly. If the
electrical socket to which the appliance must be connected is not appropriate for the
plug , replace the socket, rather than using a adaptors or the like as they could cause
overheating and burns.
Water Supply Hose
The appliance must be connected to the water mains using new hose-sets. The old hose-
sets should not be reused. Water pressure must be between 0,04 MPa and 1 MPa. If the
pressure is below the minimum consult our Service Department for advice.
• Connection: Pull The safety supply hoses
completely out from storage compartment located
at rear of dishwasher. Turn water fully on before
starting the dishwasher. Tighter the screws of the
safety supply hose to the faucet with thread
¾ inch.
• Disconnection: Turn off the water. Unscrew The
safety supply 2 hose from the faucet.
Note: Connect the cold water supply hose to a threaded 3/4(inch) connector and
make sure that it is fastened tightly in place. If the water pipes are new or have not
been used for an extended period of time, let the water run to make sure that the
water is clear and free of impurities. If this precaution is not taken, there is a risk that
the water inlet can get blocked and damage the appliance.
EN
35