Knick Stratos Pro A2 PH Serie Inicio Rápido página 13

Display
Calibration is
terminated.
Product Calibration (pH)
Action
The device returns to
measuring mode.
Product calibration
step 2:
When the sample value
has been determined,
open the product
calibration once more
(P_CAL).
The stored value is
displayed (blinking) and
can be overwritten with
the measured sample
value.
Press enter to proceed.
Display of new asym-
metry potential (based
on 25°C).
Sensoface is active.
To end calibration:
Select MEAS, then
enter
After end of calibration, the outputs remain in
HOLD mode for a short time.
Remark
From the blinking
CAL mode indicator
you see that product
calibration has not
been terminated.
Display (3 sec)
Now the device is in
HOLD mode.
To repeat calibra-
tion: Select REPEAT,
then enter
13