Cleaning Accessories - EdilKamin MIMI’ Instalación Uso Y Mantenimiento

Tabla de contenido

Idiomas disponibles

Cleaning the smoke duct

• With the stove off and cold, move the cleaning rods energetically (see page 34). Remove the lower cast iron front panel (fig. D), the

silicone stopper (fig. E) and vacuum the residue (fig. F).

The amount of residue will depend on the type of fuel and system.

Failure to carry out this cleaning procedure may cause the thermal stove to block.

Once the procedure is implemented, ensure that the inspection hatch is closed properly.

fig. D

Seasonal cleaning (implemented by the dealer)

After 2500 kg of pellets have been consumed, 'MAINTENANCE??' will appear on the display.

The thermal stove does NOT block but signals the need for the maintenance procedure to be implemented by a DEALER.

Before performing any maintenance, disconnect the appliance from the mains.

Upon the 1st ignition, the authorised DEALER will provide the thermal stove maintenance manual, which contains the

operations to be carried out during the seasonal cleaning procedure.

Clean the stove internally and externally

Carefully clean the heat exchange tubes

Carefully clean and remove dirt from the combustion chamber and the relative compartment

Clean the motors, verify mechanical and clam loosening

Clean smoke channel (replace seals on pipes) and smoke extraction fan chamber

Check the expansion tank

Check and clean the circulator

Check the sensors

Check and if necessary replace the clock battery on the control board

Clean, inspect and scrape any residue from the ignition resistance compartment and if necessary, replace it

Clean/check the Synoptic Panel

Visually inspect the electrical wires, connections and power cable

Clean the pellet hopper and check loosening of the feed screw - gear motor assembly

Check and if necessary replace the door seal

Functionality test: load the feed screw, ignite, let it run for 10 minutes and shutdown

If maintenance if not implemented, the warranty will be rendered null and void.

If the thermal stove is used very often, it is recommended to clean the smoke channel every 3 months.

When maintenance is implemented in the smoke channel, consider UNI 10847/2000 Individual chimney installations for generators

running on liquid and solid fuel. Maintenance and control.