Operating The Machine - Tornado BR 13/1 MULTIWASH Manual De Operaciones Y Mantenimiento

Liquid Discharge Control
By pulling the liquid discharge handle up, the cleaning liquid is sprayed onto the floor
in front of the machine. The flow ceases when the handle is released.
Pull Cable Connect/Disconnect Control
Insert the free end of pull cable into the valve body fitted in the cap base switch. Press and twist
clockwise to secure the cable end. Similarly, press and twist counter-clockwise to disconnect the
cable end.
Motor Overload Cut-Out
In the event of the motor getting overloaded due to improper power supply or
unexpected obstruction to the brush or drum rotation, the overload protector trips
and protects the motor from damage. If this happens, identify the cause, correct it
and reset the protector button after a minimum of 30 seconds from the tripping. After
this, you may continue working.
Important: Should the machine fail to operate, contact your dealer.

Operating the Machine

Before the Washing Operation Starts
Warning: Pre-sweep the floor to remove debris before using the
machine.
1. Ensure that the brushes are fitted properly.
2. Fill the solution tank with cleaning liquid.
3. Insert the plug into the electrical outlet.
12