Cleaning The Machine; Maintenance - Tornado BR 13/1 MULTIWASH Manual De Operaciones Y Mantenimiento

Cleaning the Machine

Warning: Switch off the machine and unplug the electric supply before
performing any cleaning operations.
1. Move the Transport/Working Mode control to the BOTTOM (Transport)
position to move the brushes off of the floor.
2. Unplug the machine and wrap the supply cord around the hooks on the
handle.
3. Remove the recovery tank, wash thoroughly and refit.
4. To prevent possible clogging of the solution lines in the solution tank,
empty any unused solution from the tank.
5. Remove the brushes by pushing out the brush shafts. Wash the
brushes thoroughly in clean water.
6. Lay the machine on its side and wipe clean the rubberized drum and
machine body with a damp cloth.
7. Reinstall the brushes after washing. It is easier to push the brush shaft
from the right hand side (identified by the electrical cable).
8. Store the machine in a dry indoor area only.

Maintenance

Warning: Before undertaking any maintenance operations or adjustments, switch off the machine
and unplug from the electrical supply.
To get the maximum life of the machine, do the following:
• Supply Cord
Regularly inspect sheath, plug and cord anchorage for damage or loose connection. Replaced if
damaged.
• Brushes
Wash the brushes regularly. Make sure that the machine is in Transport Mode when not in use.
Store additional brushes in a vertical position to avoid bending the bristles. Check for permanent
bending of bristles in a particular direction. This may occur if the machine is operated for several
days without removing the brushes, which is not recommended. If this occurs, reverse the brush
so that the bent bristles are straightened.
• Wiper Blade
If the wiper blade wears out, the water collection performance will decrease. It should be replaced
by an authorized service agent.
• Solution Feed Filter (Pump)
The filter should be periodically cleaned. Use pressurized air/water for cleaning.
• Nozzle Maintenance (Pump)
If the spray nozzle is blocked, slide the nozzle cover off and remove the nozzle. Clean it with
clean water and use a pin to unclog, then reinstall.
14