Assembly; Controls; On/Off Control - Tornado BR 13/1 MULTIWASH Manual De Operaciones Y Mantenimiento

Assembly

1. Insert the two tubular handles into the bottom handle and secure them using
the knob by tightening lightly. Make sure that the handles are assembled
according to their marked position and the cable holding hooks are pointed
towards the rear.
2. Slide the electric cable retainer into the top portion of RH handle.
3. Fit the top handle over the tubular handles and secure them with washer and
screw (2 sets). Make sure that the label on the top handle is facing the front
of the machine. Now firmly tighten both knobs and screws. Insert the plastic
caps provided to cover the screws in the top handle.
4. Pass the free end of the pull cable through the plastic guide in the RH Handle.
Press and twist clockwise to firmly secure the cable end to the lid pump
housing.
5. Fix the solution tank firmly into the bottom handle by holding the top handle.
6. Rotate the knob to hold the solution tank.
7. The brushes are loosely packed in the machine for transit; therefore the brush
shafts must be fitted before operating the machine. Push the shafts through
the brushes from the side of the machine. To remove brushes, push the
brush shaft out from the side of the machine using your fingers and pull it from
the other side.

Controls

Transport/Working Mode Control
Slide the knob to the TOP position (Working Mode) to operate the machine. Slide the knob to the
BOTTOM position (Transport Mode) to move the machine and/or park the machine. The machine will
not turn on in this mode.
Warning: Keeping the knob in the top position and moving the machine will damage the brushes.

On/Off Control

Press the pedal lightly with your foot, then pull back the handle a little to start the
motor. Pulling the handle further without pressing the pedal lowers the machine
and engages the rotating brushes onto the floor. To turn the machine off, return the
handle back to the vertical position.
Brush Pressure Controls
The control is located on the left side of the machine and has 4 positions: MINIMUM pressure when
the knob is all the way down and MAXIMUM pressure when the knob is all the way up. This allows
you to compensate for brush wear and to control the brush pressure.
11