Faults - Causes And Remedy - Soehnle Professional 7752 Instrucciones De Uso

7. Faults - causes and remedy

-0-
_____
-----
Err 05
Err 06
Err 07
Err 08
If the errors or other error messages are not rectified, please contact your Soehnle Industrial
Solutions service partner.
Display
The scale automatically resets
to zero when you switch it on. If
the scale is outside the intended
tolerance range, the display shows
--0--.
Underload: Only the lower horizon-
tal lines appear in the display panel.
Overload: Only the upper lines
appear in the display panel. The ma-
ximum weighing range is exceeded
Zeroing limit exceeded or fallen
below.
Taring with unloaded scale,
non-stoppage and overload not
possible
Printing at under- or overload not
possible
Switchover kg/lb blocked
Remedial actions
Relieve the platform and remove any
grunge.If the scale does not show
zero after a few seconds, please
contact your service partner.
Switch the scale off and on again.
The zeroing point is automatically
reset.
Place less weight on the scale.
Check the base and the leveling of
the weighing platform. Check the
scale for a force shunt.
If the error message remains after
the realignment, contact your ser-
vice partner.
Switch off/on with the unloaded sca-
le or in standby mode
45