Daikin FWEC3 Manual De Instalación Y De Uso página 28

CONFIGURATION OF DIGITAL OUTPUTS
(PARAMETERS P09,P10,P11,P12)
P09,P11
= 8
The contact is used to switch ON/OFF any external device
for humidifying the air (heating mode only). The ON/OFF
logic is based on a reading of the humidity in the room and
the SETPOINT selected with parameter P13. It follows the
diagram shown:
P09,P11
= 9
The status of the contact indicates whether the air tempe-
rature is too high compared to the temperature SETPOINT
(only in the "summer" mode); the ON/OFF logic is thus tied
to the value of the temperature SETPOINT, according to the
following step:
P09,P11
= 10
The status of the contact indicates whether the air temperature
is too low compared to the temperature SETPOINT (only in the
"winter" mode); the ON/OFF logic is thus tied to the value of
the temperature SETPOINT, according to the following step:
P09,P11
= 11
The digital output is not governed by the controller; the contact
is always open.
P09,P11
= 12
The contact status indicates that water temperature is low.
The activation/deactivation logic follows the step:
The two tables below provide a detailed explanation of the
meaning of the contact associated with each digital output:
Installation and operation manual
6
P09
NOT USED
0
OPERATING MODE
1
UNIT IN COOLING OR
Air humidity
2
HEATING MODE
UNIT IN COOLING MODE
3
UNIT IN HEATING MODE
4
CONTROLLER STATUS
5
ALARM TRIGGERED
6
EXTERNAL
7
DEHUMIDIFICATION CALL
EXTERNAL
8
HUMIDIFICATION CALL
Air temperature
HIGH ROOM
9
TEMPERATURE
LOW ROOM
10
TEMPERATURE
NOT USED
11
LOW WATER
12
TEMPERATURE
Air temperature
P11
0
OPERATING MODE
1
UNIT IN COOLING OR
2
HEATING MODE
Water temperature UNIT IN COOLING MODE
3
UNIT IN HEATING MODE
4
CONTROLLER STATUS
5
ALARM TRIGGERED
6
EXTERNAL
7
DEHUMIDIFICATION CALL
EXTERNAL
8
HUMIDIFICATION CALL
HIGH ROOM
9
TEMPERATURE
LOW ROOM
10
TEMPERATURE
WATER CIRCUIT
11
ENABLED FOR COOLING
WATER CIRCUIT
12
ENABLED FOR HEATING
DIGITAL 1 OUTPUT
P10 = 0 (NO CONTACT) P10 = 1 (NC CONTACT)
OPEN CLOSED OPEN CLOSED
CONTACT CONTACT CONTACT CONTACT
-- -- --
SUMMER WINTER WINTER SUMMER
NO YES YES
NO YES YES
NO YES YES
OFF ON ON
NO YES YES
NO YES YES
NO YES YES
NO YES YES
NO YES YES
-- -- --
YES NO NO
DIGITAL 2 OUTPUT
P12 = 0 (NO CONTACT) P12 = 1 (NC CONTACT)
OPEN CLOSED OPEN CLOSED
CONTACT CONTACT CONTACT CONTACT
-- -- --
SUMMER WINTER WINTER SUMMER
NO YES YES
NO YES YES
NO YES YES
OFF ON ON
NO YES YES
NO YES YES
NO YES YES
NO YES YES
NO YES YES
YES NO NO
YES NO NO
Advanced plus electronic controller
FC66002765
--
NO
NO
NO
OFF
NO
NO
NO
NO
NO
--
YES
--
NO
NO
NO
OFF
NO
NO
NO
NO
NO
YES
YES
FWEC3